Water Heater Pilot Light Won't Stay Lit What To Do?

The pilot light on your hot water heater might go out for a variety of reasons. Although the absence of a pilot light may signal a problem with the heater, the pilot light on a hot water heater extinguishes for a variety of causes, including gas pressure variations. Cold water will likely come out of your hot water valves if your pilot light is out. You can relight your hot water heater pilot light by following these three simple procedures.

Ascertain That the Flame Remains Lit and That Your Heater Is Operational

Hold the regulator valve down for at least a minute after the pilot light has been lighted. The thermocouple sensor will be able to re-heat as a result of this. If your pilot extinguishes, the problem is detected by this sensor, which turns your water heater off if it gets too cold. Cautiously unfasten the valve after a minute and observe whether the pilot light remains glowing. In a situation where the light stays illuminated, set the valve to "on." A "whoosh" should be heard, indicating that your main burner has re-ignited. Thereafter, the device is technically stable and can be applied in practical scenarios. Any access panels should be replaced, and any tools should be taken with you. 

Light the Pilot Light on Your Hot Water Heater

You can relight the pilot light on your water heater once you're certain there are no leaks in your water heater unit. To do so, press and hold the regulator valve in the "pilot" position. On some models, a separate button that regulates the gas to the pilot light may be required. If your device has a separate button, it will most likely be brightly colored and labeled "pilot." Look for instructions on the front of your unit that will assist you to identify all of the valves and buttons needed to relight the pilot light.

What Is the Location of the Pilot Light on a Hot Water Heater?

This section will most likely necessitate the use of a flashlight. The pilot light is normally located beneath the water tank on your unit. It's possible that you'll have to remove an access panel to get to it. The pilot light may be hidden behind a glass panel on some modern models. The pilot light should be enclosed in a tiny silver tube. If you see a flame at the end of this tube, your pilot light is on, and you'll need to consult a plumber to diagnose any additional issues with your water heater.

Let Water Heating Direct Handle Your Heating System Concerns